NEW Store Hours:

 Tuesday, Wednesday,   12pm - 7pm CST    Thursday, Friday 12pm 9pm CST

Saturday 12pm - 5pm CST, Closed Sunday and Monday


 

The   Zagi-400Electric

RYcopy

This is not another fragile electric airplane

It's a rugged Zagi with electric power!  Fully aerobatic, even at half throttle.  The Zagi-400 brings the excitement of a good day on a world-class California slope to the small field. The speed 400 motor provides this low drag 19-ounce airframe with plenty of power.  Give your arm a rest!  Motor up to those distant thermals then power-down and soar with the hawks. The best part is the rugged combat proven ding-proof EPP leading edge.  Easy foam and tape construction.  Assembles in just a few  hours.  The plastic motor tray is molded to fit the motor, speed control and a 7 or 8 cell 500-mAh N size battery. The Zagi-400 is offered by EAM as a complete kit and as a semi-kit.  

 Wing span            48 in. 
Flying weight       19 oz.
Wing loading       5.7oz.ft

ACCEPT NO SUBSTITUTE !!!!!

The complete kit contains:
bulletZagi-400 wing with hardware
bulletMolded motor tray and canopy
bulletSpeed 400 motor and prop
bullet20 amp BEC Speed control with brake
bullet7 cell N500-A battery with Deans Ultra plug
bulletDeans Ultra plug on a charging lead
bulletComplete hardware package

Price $135.00                               

The semi-kit contains:
bulletZagi-400 wing with color covering tape and hardware
bulletMolded motor tray and canopy
bulletSpeed 400 motor and prop
bulletComplete hardware package
bullet 

Price $75.00

These wings are just a few of the proto types built in the past few months.  All of the wings with speed 400 motors weigh 19 ounces.  The wing with the .02 is 20 ounces because of a different taping schedual and heavier motor.  The battery bay will accommodate a 7 or 8 cell battery pack.  Bench  tests show the 7 cell at 11,500 rpm and the 8 cell at 12,500 rpm.  Burn time was 4 and 4 1/2 minutes respectively. 

bat 7

The 7 cell is aranged side by side

bat 8

The 8 cell is made with two 4 sticks side by side

canopy copy

Vacuum molded canopy and motor tray are taped in place with fiber tape. The canopy is held in place with Velcro tabs.  The air hole in the canopy is not necessary but it looks cool.

YB motor copy

The motor/battery tray is set into the center section of the wing to reduce the profile.  The speed 400 motor fits against a stop molded into the motor tray.  A replaceable  wire tie holds the  motor in place.  There's plenty of room in the bay between the motor and the battery bay to stow the speed control, plugs and switch.  The reciever is imbedded in the wing beneath the motor tray.  A section of the motor tray is cut out to provide access to the reciever.

02 copy

I had to see what it was like.  At 20 times the price of the speed 400 the Astroflight .020 brushless motor is worth every penny.  The smaller diameter motor fits in the motor cut-out with rubber shims.  At 23,000 rpm, with a 6/3 prop, the Astro-Zagi really cooks.  I hope to fly it past some radar soon.

 

HELMET.gif (5106 bytes)

Send mail to admin@eam.net with questions or comments about this web site.
Copyright © 1999 Electric Aero Modeling Inc. DBA Electric Aero Modeling USA