PIXIE-7P
Programmable Sub Micro Motor Control
Programmable! Ideal for 3 or 4 cell NiCad/NiMH and 2 or 3 cell Lithium packs.
Programmable Sub Micro Motor Control
Programmable! Ideal for 3 or 4 cell NiCad/NiMH and 2 or 3 cell Lithium packs.
|
SPECIFICATIONS
|
|
|
Part #
|
P7P
|
|
Price
|
$34.95
|
|
Cells w/BEC
|
3-8
|
|
Cells w/o BEC
|
3-18
|
|
Continuous
|
7
amps
|
|
Surge
|
10 amps
|
|
Switching Rate
|
2800 Hz
|
|
Resistance
|
0.007 Ohms
|
|
Brake
|
No
|
|
Reversible
|
No
|
|
Low Voltage Cut-Off
|
Programmable
|
|
Size
|
0.28 x 0.58 in.
|
|
Weight (with wires)
|
0.11 oz.
|
|
Universal Connector
|
|
The Pixie-7P can be used with Speed-280 and smaller motors where current draw will be 7 amps or less. It comes with custom-made 24 gauge silicone wire for battery and motor leads.
The Pixie-7P can be set up for lower cut-off voltages for 3 or 4 cell NiCad packs, higher cut-offs for lithium cells or 10-16 cell NiCad packs, or no cut-off for micro helis. The unit comes pre-programmed for standard 5-10 cell aircraft operation (4.7V cut-off).
See the Pixie-7P User Manual (PDF) for more details.
Looking for something to handle more current? Check out the Pixie-20P.
- Battery Eliminator Circuit (BEC): eliminates receiver battery
- Safe "Power On"
- Low torque "Soft Start": protects gear boxes and belt drives from shock
- Simple setup: no complicated switches or wiring
- Tough surface mount construction
- Smooth reverse exponential throttle
- Audible Arming Signal
- Self-calibrating endpoints: maximizes usable stick travel
- Auto Motor cut-off with reset
- Auto shut-down when signal is lost
- Microprocessor Controlled